Plumbers in Lilburn, GA

Customer wanted gas line connected to indoor fireplace. Customer specifically requested that the shutoff be to the other side of the wall on the exterior of the house. Customer had someone removed porch planks for access. Ran trac pipe from black iron through the porch to a stop. Strapped properly and ran flexible supply through the wall to the appliance. Tested appliance to ensure proper function. Downstairs rear discharge toilet was leaking. Found no mounts to keep the toilet secure to the floor. When toilet was pulled drilled anchor points for all thread into the floor. Cut tank to bowl bolts and drove them into the anchors and tightened it down to the floor. Noted flange was also not secured in the wall and wasn’t flush. Secured the toilet back as well as could possibly be done. Made customer aware that due to the initial install of the toilet there would be no warranty on the pull and reset. Tested toilet and found no leaks, tested gas line and found no leaks. Gas logs are working

Price is to jet from Cleanout access in mud room to attempt to clear grease from the line. Will also jet from vent stack on roof to hit both parts of the line. If customer has to cancel for any reason will collect the $425 quoted for running the flex shaft. 11/19/24 Returned and attempted to jet from the roof. Water started to back up out of the washing machine box so jetting was stopped immediately. Attempted to run a snake the pipe but was unsuccessful. Inspected the piping in the crawlspace and gave pricing to come back and replace with 3 inch pvc for proper drain. Heavily discounted the price for the original quote and collected part of the quoted amount to cover the time for the visits and the attempted jetting. Put a discount for around the collected amount from the estimate for tomorrow. Will return on 11/20/24 to perform quoted work.

For this job, I worked on installing a new pressure regulator and main shut off 1/4 turn.

Customer attempted to replaced the handle in the hall bathroom for the shower and could not get it off. Also stated the toilet gets stuck when flushing. Found kholer flapped all gummy and deteriorating. Gave customer estimate to replace flapper and handle customer approved estimate. Installed new customer supplied handle and new flapper. Tested systems, systems are working with no leaks or issues upon departure.

Customer had high pressure in home. Pressure started around 40 psi and went to 130 when water heated. Changed the thermal as a first step since the issue was presenting as thermal expansion issues. Pressure was still high so installed customer provided pressure regulating valve in utility room wall. Customer had code issues with water heater that were pointed out but heater still has 4 years or so left for average life expectancy. Tested all work to ensure proper function and no leaks and house pressure is set to 57 psi. No warranty coverage on customer provided parts, 90 day workmanship warranty on mechanical connections.

For this job, I worked on installing new gas line for stove.

Customer was experiencing running water in home and meter spinning extremely fast. Main water shut off in basement was inaccessible. Turned on meter and followed water noise. Found hose Spigot left on and burst hose on side of home. Shut off spigot and meter stop moving.

For this job, I worked on replacing angle stop valve for guess bathroom toilet.

Finished toilet and sink , Victor need come back Tuesday do the shower panel

Water heater replacement

Faucet

Replaced leaking kitchen faucet customer supplied

For this job, I replaced a Flushmate pressure-assisted system in the men's restroom toilet. The old system was malfunctioning, causing weak flushing and inconsistent water pressure. After shutting off the water supply and draining the tank, I carefully removed the old unit and installed a new Flushmate system designed for high-performance flushing. Ensured all seals and connections were tight to prevent leaks and reconnected the water supply. After installation, I tested the toilet for proper flushing strength and pressure, confirming everything was working efficiently. The toilet is now functioning optimally with strong, reliable flushes.

For this job, I performed a comprehensive leak detection & repair. The customer had reported a leak and low water pressure in various areas of the home. After a thorough inspection, I located the issue in the main water supply line where a small crack was causing both the leak and pressure loss. I shut off the water supply, removed the damaged section, and replaced it with new PEX piping for enhanced durability. All connections were sealed and tested for leaks. After restoring water, I tested the fixtures throughout the home to ensure normal pressure and functionality. The system is now working efficiently.

Customer is going to reschedule till the counter tops are finished and the cook top is installed

Customer had a new gas stove/range they needed installed. Work performed as follows: Shut down gas to home, reworked gas line to move out of the way to allow stove to fit in properly, prepped area for install, connected stove to gas and reinstated gas to home, tested all installed components to ensure no gas leaks were present and finished installing stove. Relit pilot light to water heater.

Rebuild tank of toilet

Replaced front hose spigot

Drains

Plumbing lilburn

Plumbing lilburn

Plumbing Lilburn

Plumbing Atlanta

Water heater repair and washing machine box

Garbage disposal troubleshoot